Argantix KDC 100-100, User Manual

Page: 119 / 137

User Manual
KDC Series II DC Power Supplies 109
11 Options
11.1 Introduction
There are a number of options available for the KDC Series, both hardware and software. While
not all or no options may be present on your specific unit, this section of the manual incorporates
the user documentation for all available options. There is no separate manual for these options
except possible manual addendum's for specials engineering request (SER) systems. If your
system has an SER number as part of the model number, refer to any manual addendum that
was shipped with the unit.
Firmware options such as -704 or -160 can be accessed from the front panel through the
APPLICATIONS menu. They may also be controlled through the remote control interface. Refer
to 5005-961 KDC Programming manual for details on MIL704 commands.
Note that the
–AMD option is not implemented in firmware but rather provided through the
KDCGUI Windows software which is supplied on CD ROM CIC658. As such there is no front
panel access to this option.
The availability of any installed options can be checked from the OPTIONS screen. Toggle the
<MENU> key until the APPLICATIONS/OPTIONS screen appears as shown below. Then move
the cursor to the OPTIONS entry and press the <ENTER> key.
A sample OPTIONS screen is shown below showing both the -160- and -704 options present.
Figure 11-1: OPTIONS screen
Figure 11-2: Available options