76
Rockwell Automation Publication 1407-UM002B-EN-P - February 2019
Chapter 4
CGCM-DLR Unit Configuration
Record System Parameters
Verify and record system information and generator information that is required
for configuration of the CGCM-DLR unit. Typically this information can be
obtained from the generator nameplate, the manufacturer data sheets, and system
electrical drawings.
Equipment Required
You need a suitable personal computer with the Logix Designer application. The
application is used to configure the CGCM-DLR unit for desired operation. The
Logix Designer application contains a device profile that provides a user interface
to the CGCM-DLR unit configuration.
See the CGCM-DLR Release Notes, publication
, for information
on compatible Studio 5000 application versions and ControlLogix® controller
firmware revisions.
Create a New Module in
the ControlLogix Controller
Follow these steps to create a module in the ControlLogix controller with
Studio 5000 Logix Designer® application, version 20 or later.
Create the New 1407-CGCM-DLR Module in the I/O Configuration
After you install the CGCM-DLR Add-on Profile (see Appendix G, page
configure the Add-on Profile. Here is an example of the setup procedure that uses
a private network and the thumbwheel switch address selection. For more
information on setting the thumbwheel switches, see
.
IMPORTANT
The 1407-CGCM-DLR module uses an Add-on Profile (AOP). If not already
installed, install the Add-on Profile. See Appendix G, page
).