Agilent Technologies 4294A, Programming Manual

Page: 494 / 518

494 Appendix D
Error messages
Error number: 37
key, CALC PARMS key, or CALECPARA command) was executed, because the number of
points (NOP) within the sweep range (if the partial search function is on, within the
specified search range) is 2, they cannot be calculated. Set the number of points within the
sweep range (if the partial search function is on, within the specified search range) to 3 or
more.
37 DISPLAY BUFFER IS FULL
The use of the DRAW or MOVE command of HP Instrument BASIC made 4294A’s
display buffer full. Further write to the display buffer is impossible.
48 PHASE LOCK LOOP UNLOCKED
Anomalies in the 4294A’s internal circuit were detected (phase lock loop was not locked).
The instrument needs adjustment or repair. Contact your local Agilent Technologies sales
office or the company you purchased this instrument from.
54 TOO MUCH DATA
When data was sent from the controller to the 4294A in the FORM2, FORM3, or FORM5
data transfer format, the amount of the sent binary data was too large, or data items
exceeded the number of points (NOP) set in the 4294A. Set data to be sent or the number of
points of the 4294A correctly.
55 NOT ENOUGH DATA
When data was sent from the controller to the 4294A in the FORM2, FORM3, or FORM5
data transfer format, the amount of the sent binary data was too small, or data items did not
reach the number of points (NOP) set in the 4294A. Set data to be sent or the number of
points of the 4294A correctly.
64 TOO MANY SEGMENTS
You attempted to add segments whose quantity exceeded the maximum number (18) to the
limit line table. The number of segments you can set in the limit line table is up to 18.
74 CURRENT EDITING SEGMENT SCRATCHED
During the edit of a segment in the list sweep table or limit line table, a key or command
not related to edit of the table was executed, and the segment that was being edited became
invalid. To avoid this, press "done key" in the segments menu, SDON (command to finish
the edit of a list sweep segment), or LIMSDON (command to finish the edit of a limit
segment), and then perform other settings.
75 COMMAND IGNORED -SEGMENT NOT DONE YET
During the edit of a segment in the list sweep table or limit line table, an inappropriate edit
command (EDIT LIML, EDITLIST, LIMCLEL, LIMSEDI, LIMSADD, LIMSDEL,
SLEL, SEDI, SADD, SEGM) was sent and, as a result, the command was ignored. If
necessary, execute SDON (command to finish the edit of a list sweep segment), or
LIMSDON (command to finish the edit of a limit segment) to finish the edit of the segment,
and then perform the setting.
77 TOO MANY SEGMENTS OR POINTS
During the edit of the list sweep table, you attempted to set a value that exceeded the
maximum of segments (18), the maximum number of points per segment (201), or the
maximum number of total points in all segments (801). Set a value of the number of
segments or the number of points that does not exceed the maximum value.
82 CAN'T CHANGE -ANOTHER CONTROLLER ON BUS