Agilent Technologies 4294A, Programming Manual

Page: 303 / 518

Chapter 16 303
GPIB Command Reference
DMKRAUV
16. GPI
B
Com
m
an
d Re
fe
re
nce
( * , A - E
)
DMKRAUV
Syntax DMKRAUV <numeric>[OHM|DEG|RAD|SIE]
DMKRAUV?
Description For the active trace (set with the “TRAC” command on page 457), if the measurement
parameter is a vector value (for COMPLEX Z-Y), moves the fixed
Δ
marker at the position
of the specified measurement parameter value (subsidiary readout). Executing this
command as Query reads out the measurement parameter value of the fixed
Δ
marker
(subsidiary readout).
If the measurement parameter is a scalar value (for other than COMPLEX Z-Y) or if the
Δ
marker mode is off, executing this command causes an error and the command is ignored.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{numeric}<newline><^END>
Reads out the phase for the polar chart format. Reads out reactance (for trace A) or
susceptance (for trace B) for the complex plane format.
Corresponding
key
[Marker] -
Δ
MODE MENU - FIXED
Δ
MKR AUX VALUE
<numeric>
Description Specified measurement parameter value (subsidiary readout)
Range -100E6 to 100E6
Initial value 0
Unit Varies depending on the measurement parameter (refer to the
explanation of unit in “SCAL” on page 423).