Agilent Technologies 4294A, Programming Manual

Page: 486 / 518

486 Appendix C
GPIB command table
GPIB command list sorted according to function
Data
read/write Write Data array “INPUDATA” on page 321
Data trace array “INPUDTRC” on page 322
User calibration data array “INPUCALC{1-3}” on page 320
Fixture compensation data array “INPUCOMC{1-3}” on page 321
Marker Marker movement
setting Movement mode (Continuous/Discrete) “MKRMOV” on page 355
Trace A/B coupled mode On/Off “MKRCOUP” on page 352
Objective trace selection (Data/Memory) “MKRO” on page 356
Marker
(Main marker)
On/Off “MKR” on page 350
Read
marker
value Measurement parameter value “MKRVAL?” on page 360
Secondary measurement parameter value “MKRAUV?” on page 351
Sweep parameter value “MKRPRM” on page 358
Measurement/Sweep parameter value “OUTPMKR?” on page 387
Move Specified measurement point “MKRP” on page 357
Specified sweep parameter value “MKRPRM” on page 358
Sub marker On/Off “SMKR{1-7}” on page 438
Read
marker
value Measurement parameter value “SMKRVAL{1-7}?” on page 441
Secondary measurement parameter value “SMKRAUV{1-7}?” on page 438
Sweep parameter value “SMKRPRM{1-7}” on page 440
Measurement/Sweep parameter value “OUTPSMKR{1-7}?” on page 393
Move Specified measurement point “SMKRP{1-7}” on page 439
Specified sweep parameter value “SMKRPRM{1-7}” on page 440
Δ
marker Mode setting “DMKR” on page 302
Read
marker
value Measurement parameter value “DMKRVAL” on page 306
Secondary measurement parameter value “DMKRAUV” on page 303
Sweep parameter value “DMKRPRM” on page 305
Measurement/Sweep parameter value “OUTPDMKR?” on page 377
Move Specified measurement point “DMKRP” on page 304
Fixed
Δ
marker
only
Specified measurement parameter
value “DMKRVAL” on page 306
Specified secondary measurement
parameter value “DMKRAUV” on page 303
Specified sweep parameter value “DMKRPRM” on page 305
Unit of sweep parameter value “MKRXUNIT” on page 361
Level monitor value display mode setting “MKRMON” on page 355
Marker list function On/Off “MKRL” on page 352
Marker sweep
parameter value
→
Sweep start value “MKRSTAR” on page 359
→
Sweep stop value “MKRSTOP” on page 359
→
Sweep center value Set “MKRCENT” on page 351
Set and zoom span “MKRZM” on page 361
Zooming aperture setting “ZMAPER” on page 463
→
Measurement point of manual sweep “MKRMANP” on page 354
→
Start point of limit range “MKRLIMSTAR” on page 353
→
Stop point of limit range “MKRLIMSTOP” on page 353
Difference of sweep parameter between marker and
Δ
marker
→
Span “MKRDSPAN” on page 352
Marker
measurement
parameter value
→
Grid reference value “MKRREF” on page 358
→
X-axis offset value of limit range “MKRAMPO” on page 351
→
Start point middle value of limit range “MKRLIMVSTAR” on page 354
→
Stop point middle value of limit range “MKRLIMVSTOP” on page 354
Function Setting/Operation GPIB command