Agilent Technologies 4294A, Programming Manual

Page: 166 / 518

166 Chapter 12
Using LAN
Getting Ready for Using LAN
Setting a gateway IP address
Here follows the way of setting a gateway IP address.
Step 1. Press the [ Local ] key in the INSTRUMENT STATE block on the front panel, and press the
GATEWAY ADRESS key.
Step 2. Press the 1st key, and enter the first number of the gateway IP address delimited by a
period.
Step 3. Press the 2nd key, the 3rd key, and the 4th key, and similarly enter the second, the third,
and the fourth numbers of the gateway IP address delimited by a period.
Step 4. Press the done key.
To make settings with the GPIB command, use the command given below.
• “ADDRGW” on page 264
Setting a sub-net mask
Here follows the way of setting a sub-net mask.
Step 1. Press the [
Local
] key in the INSTRUMENT STATE block on the front panel, and press the
SUBNET MASK
key.
Step 2. Press the
1st
key, and enter the first number of the sub-net mask delimited by a period.
Step 3. Press the
2nd
key, the
3rd
key, and the
4th
key, and similarly enter the second, the third,
and the fourth numbers of the sub-net mask delimited by a period.
Step 4. Press the
done
key.
To make settings with the command, use the command given below.
• “SUBNET” on page 447
Displaying the MAC address
In the event that you need to look up the MAC address (a unique address assigned to the
device) of the 4294A, follow the steps given below, the MAC address will be displayed on
the LCD screen.
Step 1. Press the [ System ] key in the INSTRUMENT STATE block on the front panel, and press
the DIAGNOSTIC TEST key.
Step 2. Pressing the MAC ADDRESS key causes the MAC address of the 4294A to appear on the
LCD screen.
Connecting with LAN
Use a 10Base-T twisted pair (Ethertwist) cable to connect the LAN port (RJ-45 connector)
located at the lower left of the 4294A's rear panel with a vacant port of the LAN in view.