Agilent Technologies 4294A, Programming Manual

Page: 488 / 518

488 Appendix C
GPIB command table
GPIB command list sorted according to function
Analysis Waveform analysis Condition Range
setting Specified range “ANARANG” on page 267
Sweep range “ANARFULL” on page 268
Segment selection “ANASEGM” on page 268
Trace
selection Data trace “ANAODATA” on page 266
Memory trace “ANAOMEMO” on page 266
Peak definition “THRR” on page 452
Analysis
commands Maximum value search “OUTPMAX?” on page 384
Minimum value search “OUTPMIN?” on page 386
Maximum and minimum values search “OUTPMINMAX?” on page 386
Maximum positive peak search “PEAK?” on page 397
Next maximum positive peak search “NEXPK?” on page 363
Minimum negative peak search “NPEAK?” on page 364
Next minimum negative peak search “NEXNPK?” on page 362
n th positive peak search “LMAXS?” on page 343
n th negative peak search “LMINS?” on page 344
Specified measurement
parameter value search To right “TARR?” on page 451
To left “TARL?” on page 450
Analysis of maximum
difference between positive
and negative peaks value “RPLPP?” on page 413
value and peak
position “RPLPPS?” on page 414
Analysis of maximum
difference between positive
peak and its adjacent
negative peak Both sides “RPLHEI?” on page 413
Left side “RPLLHEI?” on page 413
Right side “RPLRHEI?” on page 414
Resonator
analysis 0-phase point “OUTPRESO?” on page 391
0-phase point and ripple “OUTPRESR?” on page 392
Ceramic resonator parameter “OUTPCERR?” on page 373
Equivalent circuit parameter of
crystal resonator “EQUCPARS4?” on page 312
parallel capacitance “EQUC0?” on page 311
Save, recall
and so on Save State (meas. condition, memory/user cal. data/fixture compen. data array) “SAVDSTA” on page 419
Screen graphics “SAVDTIF” on page 419
Internal
data
arrays Save ASCII file “SAVDASC” on page 416
Binary file “SAVDDAT” on page 417
Touchstone file (Data array only) “SAVDS1P” on page 418
Select Data array “SAVDAT” on page 417
Memory array “SAVMEM” on page 420
Data trace array “SAVDTRC” on page 420
Memory trace array “SAVMTRC” on page 421
User cal. data / fixture compen. data array “SAVCAL” on page 416
Update “RESAVD” on page 411
Save state as AUTOREC.STA “SAVPSTA” on page 421
Recall “RECD” on page 408
Storage device selection “STOD” on page 445
Directory Create “CRED” on page 284
Move “CHAD” on page 278
File Copy “FILC” on page 315
Delete “PURG” on page 406
Disk formatting “INID” on page 319
Function Setting/Operation GPIB command