Agilent Technologies 4294A, Programming Manual

Page: 401 / 518

Chapter 16 401
GPIB Command Reference
POIN
16. GPI
B
Com
m
an
d Re
fe
re
nce
( O -
R )
POIN
Syntax POIN <numeric>
POIN?
Description Sets the number of points measured at each sweep. To set the number-of-points setting of
each segment when creating the list sweep table, also use this command.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{numeric}<newline><^END>
Corresponding
key
[Sweep] - NUMBER OF POINTS
PORE
Syntax
PORE {ON|OFF|1|0}
PORE?
Description
Toggles on and off the port extension compensation function.
Parameters
Query response {1|0}<newline><^END>
Corresponding
key
[CAL]
-
PORT EXTENSION
-
EXTENSION on OFF
<numeric>
Description Number of points
Range 2 to 801 (Note on the number-of-points setting of a segment. The
upper limit is the smaller value: value obtained by subtracting the
sum of the numbers of points of already set segments from 801 or
201.)
Initial value 201 (Note on the number-of-points setting of a segment. If the
maximum number of settable points is less than 201, the maximum
number of settable points.)
Resolution 1
Description
ON or 1 Turns on the port extension compensation function.
OFF or 0
(initial value)
Turns off the port extension compensation function.