AEMC OX7102-CII, User Manual

Page: 105 / 208

Multimeter Mode - The "Measure" Menu
Multimeter Mode (cont'd)
The "Measure" Menu
Reference
The reference is used to select the measurement trace on which the cursor is
positioned. The cursor value is therefore relative to the measurement on this
channel.
It is only possible to choose the reference on activated channels: channels
that are not activated are displayed in a lighter colour in the sub-menu.
*
The "
9
" symbol indicates the reference selected.
ch1: Amplitude Channel CH1 is used as a voltmeter and therefore measures the amplitude of
the signal present on the input of this channel.
ch1: Ohmmeter
Channel CH1 is used as an ohmmeter and therefore measures the resistance
of the dipole wired to the input.
ch1: Continuity Channel CH1 is used as a continuity tester: there is a beep if the input
resistance is less than
≈
30 Ohms.
*
In this mode, measurements are impossible on the other channels.
ch1: Capacimeter
Channel CH1 is used as a capacitance meter and therefore measures the
capacitance of the dipole wired to the channel's input.
*
In this mode, measurements are impossible on the other channels.
ch1: Component Test
Channel CH1 is used as a component tester. This mode measures the
threshold of the diode wired to the input.
*
In this mode, measurements are impossible on the other channels.
ch1: PT100
These configurations measure a temperature using a 100
Ω
(PT100) resistive
sensor.
Do not use HX0030 probe for
following measurements :
- Ohmmeter
- Continuity
- Capacimeter
- Test Component
SCOPIX Oscilloscopes V - 105