AEMC OX7102-CII, User Manual

Page: 199 / 208

Technical Specifications
Technical Specifications (cont'd)
Communication interfaces
RS232C link configuration Selection of speed in Bauds
300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Parity selection
None, even, odd
Word length selection
8 bits or 7 bits
Stop bit number selection
1 or 2 stop bits
Protocol selection
Hard (for RTS and CTS lines)
Soft (for XON and XOFF characters)
None (no protocol)
ETHERNET Interface Type 10BASE-T (Twisted Pair)
Lead Interface scope / RJ45 8 count
Standard IEEE 802.3
RS232 / ETHERNET Interface
Connector
Double insulation, 600 V CAT III, 1000 V CAT II / inputs
Location: right-hand side of the instrument
with: 1 RS232C interface cable (HX0042)
1 twisted ETHERNET interface cable (HX0040)
Remote programming of the instrument by a PC
)
Programming of the instrument via the RS232C or ETHERNET
interface with SCPI commands
IP protocol available on ETHERNET: FTP server, TELNET,
HTTP server, LPD client, DHCP client.
Refer to the remote programming manual for the list of
commands.
Warning!
Error Messages
If one of those codes (or the addition of several codes) is present
when getting started :
Æ
a default has been detected.
In this case, contact your closest distributor
(See §. Maintenance).
Autotest : Error n° 0001 : Micro Problem
Autotest : Error n° 0002 : Flash Problem
Autotest : Error n° 0004 : RAM Problem
Autotest : Error n° 0008 : FPGA Problem
Autotest : Error n° 0010 : Numerization problem on channel 1
Autotest : Error n° 0020 : Numerization problem on channel 2
Autotest : Error n° 0040 : Numerization problem on channel 3
Autotest : Error n° 0080 : Numerization problem on channel 4
Autotest : Error n° 0100 : Analog problem on channel 1
Autotest : Error n° 0200 : Analog problem on channel 2
Autotest : Error n° 0400 : Analog problem on channel 3
Autotest : Error n° 0800 : Analog problem on channel 4
Autotest : Error n° 1000 : Problem on ETHERNET link
SCOPIX Oscilloscopes X - 199