AEMC OX7102-CII, User Manual

Page: 15 / 208

Description of the instrument
SCOPIX Oscilloscopes II - 15
Description of the instrument (cont'd)
Installation of the
battery in the
oscilloscope
*
To prevent any electric shocks, remove the Probix adapters and the
external power supply lead before installing or replacing the battery.
•
Using a coin or a screwdriver, turn by a quarter turn (counter-clockwise)
the 2 plastic screws located on the cover of the battery compartment
located at the rear of the instrument
•
Lift the cover of the battery compartment by inserting the coin under the
slot at the top of the cover.
•
Then connect the 4-point battery connector to the connector located
inside the battery compartment of the oscilloscope, taking care to
respect the failsafe systems.
•
Position the battery inside the oscilloscope compartment (battery wires
at the bottom of the oscilloscope's battery compartment).
•
Close the cover of the battery compartment and lock it by turning the 2
plastic screws by one quarter turn (clockwise).
Changing the
battery
Follow the same procedure and make sure that the replacement battery
model is identical to the original one.
The oscilloscope contains a NiMH battery. The flat battery must be handed
over to a recycling firm or a company specialized in the treatment of
dangerous waste materials.
Never dispose of the battery with other
solid waste.
For further information, contact your nearest service center.
When the oscilloscope is delivered, the battery may be discharged and
require a complete recharge. Full charging of the battery will then take
about two and a half hours, with the oscilloscope switched off.
Screw
Cover
Battery
Battery
compartment
Lower
casing