AEMC OX7102-CII, User Manual

Page: 4 / 208

General Instructions
I - 4 SCOPIX Oscilloscopes
General Instructions
Introduction
You have just purchased a portable digital oscilloscope .
Congratulations on your choice and thank you for your trust in the quality of our
products.
Here is the family of instruments to which it belongs:
SCOPIX OX 7102-C color 2-channel 100 MHz 1 GS/s sample
SCOPIX OX 7104-C color 4-channel 100 MHz 1 GS/s sample
Functions only
available
in SCOPIX II
•
SCOPE: Software trigger in automatic measurement (§. IV - 69)
•
METER: Recording of an event instant (§. V - 102)
•
FTP client (§. IV - 88)
This oscilloscope also offers the following modes:
•
Multimeter mode
•
Harmonic Analyzer mode
•
Recorder mode
•
Other possible options, see p. 92
Æ
View the site regularly.
It complies with safety standard NF EN 61010-1 (2001), double insulation,
relative to electronic measuring instruments.
For optimum service, read this manual carefully and comply with the operating
precautions.
Non-compliance with the warnings and/or operating instructions might damage
the instrument and/or its components and could prove dangerous for the user.
Precautions and
safety measures
•
This instrument has been designed for use:
- indoors
- in an environment with pollution level 2,
- at an altitude of less than 2000 m,
- at a temperature between 0°C and 40°C
- with relative humidity of less than 80% up to 31°C.
•
The safety of any system integrating the apparatus concerns the
responsibility of the assembler of the system.
•
It can be used for measurements on circuits 600V CAT III, 1000V CAT II in
relation to earth and can be powered by a 98 to 264V AC power network, with an
external power supply. However, some accessories can lead you to use this
instrument on circuits of lower voltage and category. Conform the given values
when connecting the accessory.