AEMC OX7102-CII, User Manual

Page: 49 / 208

Oscilloscope Mode - The "Vertical" Menu
SCOPIX Oscilloscopes IV - 49
Oscilloscope Mode (cont'd)
Measurement unit Modification of the selected channel's vertical scale unit.
The modification is performed by means of the stylus, using the table of
usable characters after selecting the “measure unit” zone.
The key deletes the character preceding the cursor in this area.
The vertical scale unit will be indicated in the modified channel's parameter
display.
Init Reinitializes the multiplication coefficient to 1.00 and returns to the V
measurement unit.
Validation of the selections by " OK ". Exit from the menu without modification
by " Cancel ".
This menu can also be called up by double-pressing with the stylus on the
required channel's parameter display area (CH1, CH2, CH3 or CH4).
Probix
When selected, this opens the "Probe Configuration" menu.
When a Probix HX0030 (or HX0034) probe is connected to one of the
oscilloscope's inputs, this menu becomes active.
Ñ
o
Ò
button
Buttons A and B
The can be used to switch the LED on or off.
Can be assigned to different settings (see table below).
Button A
Button B
Sensitivity Higher sensitivity Lower sensitivity
Vertical/horizontal
alignment Alignment on higher
division Alignment on lower
division
Time base Higher time base Lower time base
Trig. edge / Run-Hold RUN HOLD
Auto Meas. Ref. Meas.
AUTO MEAS. CHx
REF MEAS.
Autoset CHx / Auto 50 %
Auto CHx AUTO 50 % CHx
•
See the chapter on "The Keys" for further details on the function provided.
•
The modified parameters are updated in the control area.
•
The “ " symbol indicates the parameters elected and assigned to the
probe.
Color Modifies the color that you want to assign to the trace.
•
The “
" symbol indicates the color selected.
•
These parameters will be memorized in the probe, even after
disconnection of the oscilloscope.
When using Probix adapters, the choice of the color remains possible.
Ñ
o
Ò
A
B