•
Never use solvents that are not approved by ABB to clean the robot.
•
Do not spray from a distance closer than 0.4 m.
•
Do not remove any covers or other protective devices before cleaning the
robot.
Cleaning methods
The following table defines what cleaning methods are allowed depending on the
protection type.
Cleaning method
Protection
type
High pressure water or
steam
Rinse with water
Wipe with cloth
Vacuum
cleaner
Yes
i
.
Yes. It is highly re-
commended that
the water contains
a rust-prevention
solution.
Yes. With
cleaning deter-
gent approved
by ABB, spirit
or isopropyl al-
cohol.
Yes
Foundry
Prime
It is highly recommended
that the water and steam
contains rust preventive.
If cleaning detergents are
used they must be ap-
proved by ABB for
Foundry Prime robots.
See
cleaners and
detergents on
page 212
.
See
.
i
Perform according to section
Cleaning with water and steam on page 211
Cleaning with water and steam
Instructions for rinsing with water
ABB robots with protection types
Standard
,
Foundry Plus
,
Wash
, or
Foundry Prime
can be cleaned by rinsing with water (water cleaner).
1
The following list defines the prerequisites:
•
Maximum water pressure at the nozzle: 700 kN/m
2
(7 bar)
I
•
Fan jet nozzle should be used, min. 45° spread
•
Minimum distance from nozzle to encapsulation: 0.4 meters
•
Maximum flow: 20 liters/min
I
Typical tap water pressure and flow
Instructions for steam or high pressure water cleaning
ABB robots with protection types
Foundry Plus
,
Wash
, or
Foundry Prime
can be
cleaned using a steam cleaner or high pressure water cleaner.
2
The following list defines the prerequisites:
•
Maximum water pressure at the nozzle: 2500 kN/m
2
(25 bar)
•
Fan jet nozzle should be used, min. 45° spread
•
Minimum distance from nozzle to encapsulation: 0.4 meters
•
Maximum water temperature: 80° C
1
See
for exceptions.
2
See
for exceptions.
Continues on next page
Product manual - IRB 6640 Foundry Prime
211
3HAC040586-001 Revision: N
© Copyright 2011-2018 ABB. All rights reserved.
3 Maintenance
3.7.1 Cleaning the IRB 6640 Foundry Prime
Continued
Summary of Contents for IRB 6640 Foundry Prime
