ABB ACS880-01 Series, Firmware Instructions

Page: 118 / 664

118 Program features
FEN-xx encoder interfaces (optional) also have a connection for one KTY84 sensor.
The figure and table below show typical KTY84 sensor resistance values as a
function of the motor operating temperature.
The warning and fault limits can be adjusted by parameters.
For the wiring of the sensor, refer to the Hardware Manual of the drive.
Motor fan control logic (parameters 35.100 … 35.106 )
If the motor has an external cooling fan, it is possible to use a drive signal (for
example, running/stopped) to control the starter of the fan via a relay or digital output.
A digital input can be selected for fan feedback. A loss of the feedback signal will
optionally cause a warning or a fault.
Start and stop delays can be defined for the fan. In addition, a feedback delay can be
set to define the time within which feedback must be received after the fan starts.
Ex motor support (parameter 95.15 , bit 0)
The control program has a temperature protection function for Ex motors located in a
potentially explosive atmosphere. The protection is enabled by setting bit 0 of
parameter
95.15 Special HW settings .
Settings
Parameter groups 35 Motor thermal protection (page 323 ) and 91 Encoder module
settings (page 460 ); parameter 95.15 Special HW settings (page 476 ).
1000
2000
3000
Ohm
T
o
C
KTY84 scaling
90 °C = 936 ohm
110 °C = 1063 ohm
130 °C = 1197 ohm
150 °C = 1340 ohm
-100
0
0 100 200 300