118 Application macros
The AC500 Modbus application macro default values for the drive parameters
correspond to the ABB standard macro (parameter
, value 1 (
see section
), with the following differences:
Note
: The default slave address of the drive is 2 (parameter
but if several drives are used, the address must be unique for each drive.
For more information regarding the Starter kit configuration, please refer to
AC500-eCo and ACS355 quick installation guide
(2CDC125145M0201 [English]),
and
ACS355 and AC500-eCo application guide
(2CDC125152M0201 [English]).
No.
Name
Default value
10 (
8 (
)
8 (
)
8 (
)
0 (
)
1 (
)
2
192 (
1 (
2 (
101
303
305
1 (
Summary of Contents for ACS355 series
