3Com Switch 8800 Configuration Guide
Chapter 46 System Maintenance and Debugging
46-23
modu
-
name
specifies the module name;
default
represents all the modules;
all
represents all the information filter configuration in channelnum chunnel except default;
level
refers to the severity levels;
severity
specifies the severity level of information.
The information with the level below it will not be output.
channel
-
number
specifies the
channel number and
channel
-
name
specifies the channel name.
When defining the information sent to log buffer,
channel
-
number
or
channel
-
name
must be set to the channel that corresponds to logbuffer direction.
Every channel has been set with a default record, whose module name is
default
and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select
debugging
as the information type when configuring information source,
meantime using the
debugging
command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following configuration in system view:
Table 46-37
Configure the output format of time-stamp
Operation
Command
Configure the output format of the
time-stamp
info-center timestamp
{
log
|
trap
|
debugging
} {
boot
|
date
|
none
}
Output time-stamp is disabled
undo info-center timestamp
{
log
|
trap
|
debugging
}
46.5.7 Sending the Configuration Information to the Trap Buffer
To send configuration information to the trap buffer, follow the steps below:
1) Enabling
info-center
Perform the following configuration in system view.
Table 46-38
Enable/disable info-center
Operation
Command
Enable info-center
info
-
center enable
