3Com Switch 8800 Configuration Guide
Chapter 46 System Maintenance and Debugging
46-16
Every channel has been set with a default record, whose module name is
default
and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select
debugging
as the information type when configuring information source,
meantime using the
debugging
command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information. This configuration will
affect the timestamp of the displayed information.
Perform the following configuration in system view:
Table 46-23
Configure the output format of time-stamp
Operation
Command
Configure the output format of the
time-stamp
info-center timestamp
{
log
|
trap
|
debugging
} {
boot
|
date
|
none
}
Output time-stamp is disabled
undo info-center timestamp
{
log
|
trap
|
debugging
}
4)
Configuring the loghost
The configuration on the loghost must be the same with that on the switch. For related
configuration, see the configuration examples in the later part.
46.5.4 Sending the Configuration Information to Console terminal
To send configuration information to console terminal, follow the steps below:
1) Enabling
info-center
Perform the following configuration in system view.
Table 46-24
Enable/disable info-center
Operation
Command
Enable info-center
info
-
center enable
Disable info-center
undo info
-
center enable
