3Com Switch 8800 Configuration Guide
Chapter 4 User Interface Configuration
4-10
4.2.6 Configuring Modem Attributes
When logging in the switch via the Modem, you can use the following commands to
configure these parameters.
Perform the following configuration in AUX user interface view.
Table 4-19
Configure Modem attributes
Operation
Command
Set the interval since the system receives
the RING until CD_UP
modem timer answer seconds
Restore the default interval since the
system receives the RING until CD_UP
undo modem timer answer
Configure auto answer
modem auto-answer
Configure manual answer
undo modem auto-answer
Configure to allow call-in
modem call-in
Configure to bar call-in
undo modem call-in
Configure to permit call-in and call-out.
modem both
Configure to disable call-in and call-out
undo modem both
4.2.7 Configuring Redirection
I. Send command
The following command can be used for sending messages between user interfaces.
Perform the following configuration in user view.
Table 4-20
Configure to send messages between different user interfaces.
Operation
Command
Configure to send messages between
different user interfaces.
send
{
all
|
number | type number
}
II. Auto-execute command
The following command is used to automatically run a command after you log in. After a
command is configured to be run automatically, it will be automatically executed when
you log in again.
This command is usually used to automatically execute
telnet
command on the
terminal, which will connect the user to a designated device automatically.
Perform the following configuration in user interface view.
