3Com Switch 8800 Configuration Guide
Chapter 46 System Maintenance and Debugging
46-27
Every channel has been set with a default record, whose module name is
default
and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select
debugging
as the information type when configuring information source,
meantime using the
debugging
command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
This configuration will affect the timestamp of the displayed ifnormation.
Perform the following configuration in system view:
Table 46-45
Configure the output format of time-stamp
Operation
Command
Configure the output format of the
time-stamp
info-center timestamp
{
log
|
trap
|
debugging
} {
boot
|
date
|
none
}
Output time-stamp is disabled
undo info-center timestamp
{
log
|
trap
|
debugging
}
4)
Configuring of SNMP and network management workstation on the switch
You have to configure SNMP on the switch and the remote workstation to ensure that
the information is correctly sent to SNMP NM. Then you can get correct information
from network management workstation. SNMP configuration on switch refers to
Chapter 47 SNMP Configuration
46.5.9 Displaying and Debugging Info-center
After the above configuration, execute the
display
command in any view to view the
running state of the info-center. You also can authenticate the effect of the configuration
by viewing displayed information. Execute the
reset
command in user view to clear
statistics of info-center.
Perform the following configuration in user view. The
display
command still can be
performed in any view.
