3Com Switch 8800 Configuration Guide
Chapter 46 System Maintenance and Debugging
46-21
This configuration will affect the timestamp of the displayed information.
Perform the following configuration in system view:
Table 46-32
Configure the output format of time-stamp
Operation
Command
Configure the output format of the
time-stamp
info-center timestamp
{
log
|
trap
|
debugging
} {
boot
|
date
|
none
}
Output time-stamp is disabled
undo info-center timestamp
{
log
|
trap
|
debugging
}
4)
Enabling terminal display function
To view the output information at the Telnet terminal or dumb terminal, you must first
enable the terminal display function, and then the corresponding terminal display
function of log information on the switch.
For example, if you have set the log information as the information sent to the Telnet
terminal or dumb terminal, now you need to use the terminal monitor command to
enable the terminal display function and the
terminal logging
command to enable the
terminal display function of log information on the switch, then you can view the
information at the Telnet terminal or dumb terminal.
Perform the following configuration in user view:
Table 46-33
Enable terminal display function
Operation
Command
Enable terminal display function of log, debugging
and trap information
terminal monitor
Disable terminal display function of the above
information
undo terminal monitor
Enable terminal display function of debugging
information
terminal debugging
Disable terminal display function of debugging
information
undo terminal debugging
Enable terminal display function of log information
terminal logging
Disable terminal display function of log information
undo terminal logging
Enable terminal display function of trap information
terminal trapping
Disable terminal display function of trap information
undo terminal trapping
46.5.6 Sending the Configuration Information to the Log Buffer
To send configuration information to the log buffer, follow the steps below:
