3Com Switch 8800 Configuration Guide
Chapter 4 User Interface Configuration
4-9
Note:
When a user logs in the switch, the command level that it can access depends on two
points. One is the command level that the user itself can access, the other is the set
command level of this user interface. If the two levels are different, the former will be
taken. For example, the command level of VTY 0 user interface is 1, however, you have
the right to access commands of level 3; if you log in from VTY 0 user interface, you can
access commands of level 3 and lower.
IV. Setting the command priority
The following command is used for setting the priority of a specified command in a
certain view. The command levels include visit, monitoring, configuration, and
management, which are identified with 0 through 3 respectively. An administrator
assigns authorities as per user requirements.
Perform the following configuration in system view.
Table 4-17
Set the command priority
Operation
Command
Set the command priority in a specified
view.
command-privilege level
level
view
view command
Restore the default command level in a
specified view.
Undo command-privilege
view
view
command
V. Setting input protocol for a user terminal
You can use the following command to set input protocol for a user terminal. The input
protocol type can be TELNET, SSH or all.
Perform the following configuration in user interface view.
Table 4-18
Set input protocol for a user terminal
Operation
Command
Set input protocol for a user terminal
protocol inbound
{
all
|
telnet
|
ssh
}
By default, the input protocol type for a user terminal is all.
