YASKAWA GA800 Series, Техническое обслуживание и устранение неисправностей

Страница: 475 / 566

Startup
Procedure
and
T
est
Run
6
6.6 Keypad Operation
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting 475
3.
Push or to select [Initial Settings], then push .
4.
Push or to select [Language Selection], then push .
5.
Push or to select the language, then push .
The procedure to set the keypad language is complete.
◆
Set the Date and Time
The procedure in this section shows how to set the date and time.
Note:
• Refer to Replace the Keypad Battery on page 69 for information about the battery installation procedure.
To set the drive to detect an alarm when the battery is dead or when the clock is not set, install the battery then set o4-24 = 1 [bAT Detection
selection = Enable (Alarm Detected)] .
•
If the keypad does not have a clock battery, you must set the date and time each time you energize the drive.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown on , push (Back) to show [Home] on .
2.
Push (Menu).