YASKAWA GA800 Series, Техническое обслуживание и устранение неисправностей

Страница: 21 / 566

Periodic
Inspection
and
Maintenance
1
1.1 Section Safety
YASKAWA TOEPYAIGA8001B GA800 Drive Maintenance & Troubleshooting 21
WARNING
Electrical Shock Hazard
Do not modify the drive body or drive circuitry.
Modifications to drive body and circuitry can cause serious injury or death, will cause damage to the drive, and will
void the warranty. Yaskawa is not responsible for modifications of the product made by the user.
Sudden Movement Hazard
Make sure that you align the phase order for the drive and motor when you connect the motor to
drive output terminals U/T1, V/T2, and W/T3.
If the phase order is incorrect, it can cause the motor to run in reverse. If the motor accidentally runs in reverse, it
can cause serious injury or death.
CAUTION
Burn Hazard
Do not touch a hot drive heatsink. De-energize the drive, wait for a minimum of 15 minutes, then
make sure that the heatsink is cool before you replace the cooling fans.
If you touch a hot drive heatsink, it can burn you.
NOTICE
Damage to Equipment
When you touch the drive and circuit boards, make sure that you observe correct electrostatic
discharge (ESD) procedures.
If you do not follow procedures, it can cause ESD damage to the drive circuitry.
Use the instructions in this manual to replace the cooling fans. When you do maintenance on the
fans, replace all the fans to increase product life.
If you install the fans incorrectly, it can cause damage to the drive.
Make sure that all connections are correct after you install the drive and connect peripheral
devices.
Incorrect connections can cause damage to the drive.
Do not energize and de-energize the drive more frequently than one time each 30 minutes.
If you frequently energize and de-energize the drive, it can cause drive failure.
Do not operate a drive or connected equipment that has damaged or missing parts.
You can cause damage to the drive and connected equipment.
Note:
Do not use unshielded cable for control wiring. Use shielded, twisted-pair wires and ground the shield to the ground terminal of the drive.
Incorrect wiring can cause electrical interference and unsatisfactory system performance.