YASKAWA GA800 Series, Руководство по программированию

Страница: 551 / 644

Keypad
Use
and
T
est
Run
3
3.4 Keypad Operation
YASKAWA TOEPYAIGA8002B GA800 Drive Programming 551
3.4 Keypad Operation
Note:
Make sure that you use a keypad with FLASH number 1004 or later. Keypads with FLASH numbers 1003 and earlier will not show
characters correctly.
◆
Home Screen Display Selection
This section gives information about the functions that you can control from the HOME screen and the content shown
on the HOME screen.
■
View Monitors Shown in Home Screen
This figure shows monitor data in the data display area of the HOME screen.
•
To change what the screen shows, change the setting for o1-40 [Home display selection] .
• When o1-40 [Home display selection] is set to “ Custom Monitor ” , and there is more than one screen, use or
to switch between screens.
■
JOG Operation
Push to illuminate . Push (JOG) to run the motor. Release to stop the motor.
■
Change Motor between Forward/Reverse Run
You can change the direction of motor rotation when operating the drive from the keypad. Push to illuminate
.
Push and hold (FWD/REV) to toggle the direction of motor rotation between forward and reverse.
■
Show the Standard Monitor
Push to show the standard monitor ( Ux-xx ). Push (HOME) to go back to the HOME screen.
Note:
When a fault, minor fault, or an error occurs, push to show the content of the fault. Push again to show the standard monitor ( Ux-
xx ).
■
Change the Frequency Reference Value
1. Push to access the screen to change the frequency.