Wexxar WF30T, Руководство по эксплуатации и обслуживанию

Страница: 20 / 190

WF30T Case Former Installation
2-7
2.5 Location, Leveling and Conveyors
2.5.1 Location
When selecting the machine location, carefully consider the following points:
•
Adequate access around the machine for correct operation and service.
•
Sufficient room to open the bi-fold and access doors (including control enclosure).
•
A minimum 3-foot clearance in front of the main electrical enclosure.
•
Sufficient clearance for magazine width increases that occur when the machine is set
up for large cases.
•
Easy lift-truck access.
•
Good access for magazine loading and nearby space for pallet loads of flat cases
.
2.5.2 Leveling
•
Set the machine for maximum Dimension ‘C’ (with the magazine in the maximum
rearward position).
•
Use at least a two-foot carpenter level, marked on one end so that you always work to
the same bubble line and with the concave side down (if there is one).
•
Open the bi-fold doors, and position the spirit level along the length of the main frame to
level one side of the machine.
•
Adjust the machine leveling feet on this side of the machine as appropriate to centralize
the bubble between the parallel lines.
•
Position the spirit level on the main frame along the width of the machine at the discharge
end.
•
Adjust the machine leveling feet under the magazine and discharge ends on the opposite
side in order to centralize the bubble between the parallels.
•
Tighten the level adjuster lock nuts.
•
Anchor the machine to the floor.
CAUTION!
Note that the bi-fold doors jut out further when the ‘C’
adjustment is shortened for shorter cases. To adjust
Dimension ‘C’, refer to Section 7.5: ‘Case Length’. This
increase in machine width should be taken into
consideration while ensuring easy access for magazine
loading.