Wexxar WF30T, Руководство по эксплуатации и обслуживанию

Страница: 118 / 190

WF30T Case Former Troubleshooting & Repairs
- 10-105 -
Table 54: Jaw too slow; forming head speed normal
Problem Possible Cause Solution
Adjust the regulator’s set point.
Mast cylinder: 70 PSI.
Low Air Pressure Regulator set point too low
Air pressure at machine’s main
regulator: 90 PSI.
Auto drain of the filter is not
working; water accumulated in
the cup is not discharged
Drain the water in the filter cup
and fix the auto drain valve or
replace the filter cup.
Water
Condensation
Too much water in the air
supply
Dry the air before it enters the
machine.
Overheating /
Too cold Usually caused by high / low
ambient temperature When ambient temperature is
over 60° or below 0° centigrade.
Table 55: Forming head not moving
Problem Possible Cause Solution
Compressed
air not
connected
Connect air supply.
Mechanical
Jam
Clear mechanical jam.
Socket loose Tighten socket.
Open Circuit
Cable broken Replace cable.
Overheating /
Too cold Usually caused by high / low
ambient temperature When ambient temperature is over
40° or below 0° centigrade.
Auto drain of the filter is not
working; water accumulated in
the cup is not discharged Drain the water in the filter cup and
fix the auto drain valve or replace
the filter cup.
Water
Condensation
Too much water in the
air supply Dry the air before it enters the
machine.