Wexxar WF30T, Руководство по эксплуатации и обслуживанию

Страница: 90 / 190

WF30T Case Former Other Machine Adjustments
8-77
8.7 Quick Size Change Guide
The case size change table (Table 30) in this section is used to make case size changeover
simpler and faster. For each case, the optimum set-up parameters can be determined and
entered into Table 30. Once established, the table is a guide for operators, greatly reducing the
time required to adjust and fine-tune the machine set-up.
Most table entries are self-explanatory. For example, ‘Enter Flat Case Blank Height’ (Dimension
‘B’) in terms of the medium blue scale reading on the mast track. Other settings, such as
‘Magazine Pusher’ or ‘Jawplates’, are not so straightforward.
There are some other adjustments in Section 7:
‘Case Size Adjustments’
and Section 9.4:
‘Typical Maintenance Adjustments’
, which do not lend themselves to tabulation. They will need to
be set as required, following the guidelines in the relevant section. These adjustments are listed
below.
Table 29: Sensor Adjustment References
Adjustment Section Note
Case Down Sensor (LS-7)
Section 8.4:
‘Sensor LS-7
Adjustment’
Normally not adjusted.
Head Partly Down Sensor
(LS-6) Section 9.4.2:
‘Mechanism
Speeds’
Required when changing
speed of mast cylinder.
NOTE: Make a copy of Table 30 and keep the original
for future use.
NOTE:
This quick-change guide should not be used as a
substitute for proper operator training. All personnel
making adjustments to this machine should be familiar with
Section 7: ‘Case Size Adjustments’ and Section 9.4: ‘Typical
Maintenance Adjustments’ of this manual.