WF30T Case Former
Operating Procedures
6-51
6.3.2 Loading the Magazine
The case magazine must contain an adequate number of cases for proper operation. In addition,
note the following points:
•
The cases must be right way up and properly folded.
Every case that is loaded
upside down or improperly folded will cause a jam. It is much easier to reposition the
case in the magazine than it is to clear a jammed machine. When viewed from the
discharge end, the loaded cases must have their longest panel nearest to the mast
structure. Alternately, when viewed from the infeed side, the short panel should be
closest to the mast.
•
Some cases have an off-center mark printed on the folded edge. This is a great help in
spotting upside-down cases in the magazine. If your cases are bundled and strapped, do
not remove the strapping until you have placed the cases in the magazine. This keeps
the cases all aligned, and simplifies loading.
•
Do not let the magazine quantity get too low.
If there are fewer than 12" of cases
in the magazine, reloading may require stopping the machine. This is because the
magazine pusher can interfere with the case separator and/or the guarding when
insufficient cases are present. If your machine is equipped with the optional low
magazine sensor, a warning will be emitted when it is necessary to reload the magazine.
•
The magazine can be reloaded without stopping the machine, if desired.
a) Position fresh cases in the magazine behind the magazine pusher arm.
b) While applying modest pressure to the stacked cases to maintain contact, switch
the pusher air valve at the center of the magazine
OFF
.
c) Lift the magazine pusher arm up to clear the stacked cases, pull it back behind
the new cases, and reposition it to push on the last case.
d) Switch the magazine pusher valve back to
ON
.
e) Remove any banding straps that may be around the case bundles and the job is
finished.
•
Always load cases in the magazine standing vertically upright
. If cases sit at
an angle in the magazine, improper operation will result.
Содержание WF30T
