Wexxar WF30T, Руководство по эксплуатации и обслуживанию

Страница: 41 / 190

WF30T Case Former Controls
5-28
4) Touchscreen Display
The following control descriptions refer to the software ‘buttons’ or ‘switches’ that appear on the
display screen, and which act as though they were hardware equivalents. Touching the
‘Service’
screen anywhere will activate the
‘Main Control’
screen. Normal machine-status messages are
shown in the top of the
‘Main Control’
screen in the
‘Machine Alarm’
display.
Machine fault messages are shown in red on the machine status display. They identify serious
problems with the machine. Amber remedy messages and cautionary messages of impending
faults are scrolled in the
‘Warning Message’
display immediately below the machine status
messages. The cautionary messages include warnings that machine components may be
running too fast or too slowly.
5) ‘MAIN CONTROL’ Button
This button is located to the bottom left of the touchscreen when the
machine is in
JOG
mode. Pressing the
‘MAIN CONTROL’
button will
take the machine back to the
‘Main Control’
screen.
In the bottom, left-center of the
‘Main Control’
screen is a
‘DRY
CYCLE ON/OFF’
machine status indicator. To the right of this
indicator is a
‘REMOTE DEMAND ON/OFF’
status indicator.
•
In the
CYCLE
mode, which is the default, the machine
automatically picks cases from the magazine and forms them
without any additional operator input.
Figure 5-4: 'Main Control' Screen
– machine stopped
Figure 5-5: ‘Service’ Screen
Figure 5-6: 'MAIN
CONTROL' Button