VESPA GTV 125, Руководство по обслуживанию станции

Страница: 86 / 278

(-) must be connected to the -negative clamp while the other two red wires marked (+) must be con-
nected to the clamp marked with the +positive sign.
Checking the electrolyte level
The electrolyte level must be checked frequently and must reach the upper level. Only use distilled
water, to restore this level. If it is necessary to add water too frequently, check the vehicle's electrical
system: the battery works overcharged and is subject to quick wear.
- Remove the short closed tube and the caps, then
pour sulphuric acid into the cells using the type
specified for batteries with a specific gravity of
1.26, corresponding to 30 Bé at a minimum tem-
perature of 15°C until the upper level is reached.
- Allow to stand for at least 2 hours, then top up the
level with sulphuric acid.
- Within the following 24 hours, recharge with the
specific (single) or (multiple) battery charger at an
intensity approx. to 1/10 of the battery rated ca-
pacity and until the acid density is approximately
1.27, corresponding to 31º Bé, and these values
are stabilised.
- After charging, level the acid ( adding distilled
water ). Close and clean carefully.
- Once the above operations have been per-
formed, install the battery in the vehicle ensuring
that it is wired up properly.
Specific tooling
020333Y Single battery charger
020334Y Multiple battery charger
1 Hold the vertical tube
2 Look at the level
3 The float must be freed
Electrical system
Vespa GTV 125
ELE SYS - 22