Toshiba Stratagy Flash, Руководство по установке и обслуживанию

Страница: 99 / 260

Configure Stratagy
SMDI Serial Integration
Stratagy I&M 06/02
4-35
Configur
e Stratagy
Note If packets are not seen, the host phone system may not be sending the packets or there is a
bad cable or connection.
3. Re-check configuration parameters in the Stratagy. Validate the data protocol parameters and
COM port are properly defined in the Serial Port Definition of the Stratagy System
Configuration.
4. Call each port individually and validate by the packet information that the Terminal number for
the first port correlates with the value defined by smdi_base_port in the Stratagy System
Configuration. Validate remaining Terminal numbers are sequential from the first.
5. Validate that the number of the Called Extension (defined in the packet) is a valid User ID. If
the User ID is less than seven digits long then the number is prefixed with zeros in the packet.
If the User ID is less than seven digits long but the Called Extension defined in the packet is
prefixed by numbers other than zero that information must be defined in the System Integration
Patterns screen (see
page 4-9 ).
SMDI Calling Party Identification
The Strata CTX/Strata DK telephone system only provides the Stratagy with incoming Calling
Party ID via SMDI integration. Data messages or packets are sent into the system to provide
information concerning the type of call and the calling party ID.
Note When configuring the Stratagy for SMDI, make sure both the Stratagy and the telephone
system are configured concurrently. If the phone system is configured for a 10-digit Calling
Party ID, the IVP8 must also have the proper 10-digit integration patterns in the System
Integration Patterns screen (see
page 4-5 ). Also make sure the correct notification template
has been selected in the User ID Notify screen.
See “SMDI Serial Integration” on page 4-32 for detailed information on SMDI, caller ID, and %K
token use.
Some examples of the available applications are adding the Calling Party ID to the message header,
playing a specific greeting and routing a call based on the telephone number received.
Calling Party ID in Message Header
One new application is playing the Calling Party ID in the header information of the message. To
configure this option, in addition to making the required changes for SMDI integration in the
Stratagy System Configuration, you must make sure the play_caller_id parameter is set to True.
Call Routing Based on Caller ID
The Stratagy can also play a specific greeting or route a call based on the telephone number received
from the SMDI/Caller ID information.
Each port on the Stratagy system stores the %K token’s value individually so multiple ports can run
this application simultaneously. The value of the %K token lasts for the duration of the call and is
cleared when the Stratagy voice port goes idle. When Stratagy transfers the call to a Strata DK LCD
telephone, the Caller ID information displays on the LCD.