Toshiba Stratagy Flash, Руководство по установке и обслуживанию

Страница: 70 / 260

Configure Stratagy
Tools Utility
4-6
Stratagy I&M 06/02
...or
2
.The changes are transmitted to Stratagy but Stratagy is not shut down or restarted. Until
you restart Stratagy, the changes do not take effect.
...or
3
. The changes you made are cancelled and not saved.
6. If you pressed
1
to save the changes, press any key to reboot. The DOS prompt displays. To
continue, you must re-enter Stratagy Admin.
Modify a Dial Code
If the telephone system you desire does not appear on the Telephone System Dial Codes Screen or
further modifications to the dial codes are needed, you can modify a dial code parameter.
1. From the Tools menu, press
4
. The Telephone System Configuration screen displays.
2. From the Telephone System Configuration screen, press
1
. The Telephone System Dial Codes
screen displays.
3. Use the arrow keys (
↑↓
) and/or
Page Up
and
Page Down
keys to highlight the dial code
parameter and press
Enter
.
The line appears at the top of the screen.
4. Modify the dial code using the line editor at the top of the screen.
See Table 4-2 below for a listing of the dial code parameters and their definitions and settings.
5. After making the change(s), press
ESC
. The Telephone System Configuration screen displays.
6. From the Telephone System Configuration screen, press
1
. The changes are transmitted to
Stratagy and Stratagy is shut down and restarted. By shutting down and restarting Stratagy, the
changes take effect.
...or
2
.The changes are transmitted to Stratagy but Stratagy is not shut down or restarted. Until
you restart Stratagy, the changes do not take effect.
...or
3
. The changes you made are cancelled and not saved.
7. If you pressed
1
to save the changes, press any key to reboot. The DOS prompt displays. To
continue, you must re-enter Stratagy Admin.
Table 4-2 Telephone System Dial Codes - Definitions and Settings
Parameter/Description
# Dial code to put a caller on transfer hold:
The code Stratagy sends the telephone system, before attempting to transfer a call to an extension, to put the
current call on “transfer hold” and send the transfer (or intercom) dial tone.
Typical value:
F
-
(hookflash)
# Dial code to use when there is no transfer dialtone:
The code Stratagy dials to return to the caller when:
Stratagy is configured to verify transfer dial tone exists before attempting to transfer a call to the requested
extension
–and–
transfer dial tone is not available.
When this occurs, Stratagy treats the attempted transfer the same as a busy extension.
Typical value: F- (hookflash)