1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
© 2018 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
1-31
e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC
Perform adjustments according to the following procedure while checking the chart output by [05
ADJUSTMENT MODE].
<Notes>
• Since the reproduction ratio may vary due to expansion and contraction of paper immediately
after the image is printed out, it is recommended to measure its dimension after at least 3 minutes
have passed.
• Use the second drawer, A3/LD.
• Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
<Procedure>
(1)Select [05 ADJUSTMENT MODE].
(2)Key in a code and press the [START] button.
(3)Key in the adjustment value. (To correct a value, press [CLEAR].)
(4)Press [OK] to store the value. → The equipment goes back to the ready state.
(5)Check the chart.
If the image is not in the desired reproduction ratio, repeat steps (2) to (5).
(3) (b) Image distortion adjustment
Adjustment of tilted images on the trailing edge
In this procedure, it is recommended to use the print sample (05-316, 04-141, 04-410) as shown
below.
[05] Code
Function
Remarks
05-4001
The larger the value is, the larger the reproduction ratio in the
primary scanning direction becomes. (0.1%/step)
Acceptable values: 0 to 255 (Default: 128)
②15m m
④15m m
①15m m
③15m m
⑥15m m
⑧15m m
⑦15m m
⑤15m m
Front side
Rear side
Center position
(top-bottom and left-right symmetric)
Содержание e-STUDIO2010AC
Страница 1: ...File No SME18003400 R180821V5800 TTEC Ver00F_2018 10 ...
Страница 6: ...Revision Record Ver00 2018 10 19 Page Contents All Initial release ...
Страница 339: ......
Страница 340: ......