Chapter 2: DSM V6100 Hardware Appliance
Configuring a V6100 Appliance
DSM Installation and Configuration Guide
Copyright 2009 - 2020 Thales Group. All rights reserved.
25
REQUIREMENT
VALUE
eth0—this interface is DHCP enabled by default. DHCP
must be disabled to assign a static IP address
Note:
DSM DHCP support enables configuration of
the appliance IP address, net mask, gateway, and
search domain. It does not configure an appliance
host name, or an NTP server.
DHCP Server
If you choose to use static IP addressing, you need the
following:
IP address:
net mask:
default gateway (optional):
eth1—this interface comes configured with a default IP
address; 192.168.10.1.
We recommend that you retain this configuration in the
event that you need a recovery option to access the
appliance.
DHCP Server
If you choose to use static IP addressing, you need the
following:
IP address:
net mask:
default gateway (optional):
bond0—this interface is used when the eth0 and eth1
interfaces are aggregated into a single logical interface for
load balancing/fault tolerance.
If configured, the
bond0
interface supersedes the eth0 and
eth1 interfaces, and must be used to access the DSM
appliance.
DHCP Server
If you choose to use static IP addressing, you need the
following:
IP address:
net mask:
default gateway (optional):
IPMI NIC—this interface comes configured with a default IP
address; 192.168.10.10
This interface supports DHCP, refer to the CLI chapter in
the
DSM Administrators Guide
for details.
DHCP Server
If you choose to use static IP addressing, you need the
following:
IP address:
net mask:
default gateway (optional):
HA node 1 DSM Hostname: FQDN (lowercase only)
HA node 2 DSM Hostname: FQDN (lowercase only)
Domain Name Server (DNS) addresses - up to 3 plus
optional DNS search domain.
NTP server FQHN or IP address (if applicable)
DSM V6100 appliance with DSM software
Certificate Information
DSM Hostname: FQDN (must be an exact match to the
hostname)
Name of your organizational unit
Name of your organization
Name of your city or locality. Must be fully spelled out, no
abbreviations, e.g., San Jose,
not
SJC.
Name of your state or province. Must be fully spelled out,
no abbreviations, e.g., California
not
CA
Two-letter country code
