Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 353 / 834

6A1-62 ENGINE MECHANICAL (G16 ENGINE)
5) Install bearing cap (1) :
Point arrow mark (2) on cap to crankshaft pulley side (3).
Tighten cap nuts to specification.
Tightening torque
Connecting rod bearing cap nut
(a) : 35 N·m (3.5 kg-m, 25.5 lb-ft)
6) Reverse removal procedure for installation, as previously
outlined.
7) Adjust water pump drive belt tension referring to “Cooling
Fan Belt Tension Check and Adjustment” in Section 6B.
8) Adjust power steering pump belt tension or A/C compressor
belt tension, if equipped. Refer to “Engine” in Section 0B.
9) Adjust intake and exhaust valve lashes referring to “Valve
Lash (Clearance)” in this section.
10) Adjust accelerator cable play and A/T throttle cable (for 4 A/T
model) play referring to “Accelerator Cable Adjustment” and
“A/T Throttle Cable Adjustment” in Section 6E1.
11) Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been rein-
stalled.
12) Refill engine with engine oil referring to “Engine Oil and Filter
Change” in Section 0B.
13) Refill cooling system referring to “Cooling System Flush and
Refill” in Section 6B.
14) Refill front differential housing with gear oil referring to “Main-
tenance Service” in Section 7E.
15) Connect negative cable at battery.
16) Verify that there is no fuel leakage, coolant leakage, oil leak-
age and exhaust gas leakage at each connection.
17) Verify that ignition timing is within specification referring to
“Ignition Timing Check” in Section 6F1.