Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 451 / 834

6A2-76 ENGINE MECHANICAL (H25 ENGINE)
INSTALLATION
1) Clean mating surface on cylinder head and cylinder block.
Remove oil, old gasket and dust from mating surface.
2) Install knock pin (4) to cylinder block.
3) Apply sealant “A” to cylinder head gasket (1) as shown in fig-
ure.
“A” : Sealant 99000-31250
Sealant amount
Width “w” : Min. 4 mm (0.157 in.)
4) Install new cylinder head gasket to cylinder block as shown
in figure. Carved lot number (5) on cylinder head gasket
should face up (toward cylinder head side).
5) Install cylinder head to block.
After applying oil to cylinder head bolts, tighten them gradu-
ally as follows.
a) Tighten all bolts to 53 N·m (5.3 kg-m, 38.5 lb-ft) according
to numerical order in figure.
b) In the same manner as in a), tighten them to 84 N·m (8.4
kg-m, 61.0 lb-ft).
c) Loosen all bolts until tightening torque is reduced to 0 in
reverse order of tightening.
d) In the same manner as in a), tighten them to 53 N·m (5.3
kg-m, 38.5 lb-ft).
e) In the same manner as in a) again, tighten them to speci-
fied torque.
Tightening torque
Cylinder head bolt
(a) : 105 N·m (10.5 kg-m, 76.0 lb-ft)
Cylinder head bolt (hex hole bolt)
(b) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
6) Install water outlet cap.
[A] : RH (No.2) bank
[B] : LH (No.1) bank
2. Crankshaft pulley side
3. Flywheel side
NOTE:
Don’t forget to install hex hole bolts (1) as shown in fig-
ure.
[A] : RH (No.2) bank
[B] : LH (No.1) bank
2. Crankshaft pulley side
3. Flywheel side