Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 780 / 834

CRANKING SYSTEM (0.9 kW, 1.2 kW and 1.4 kW Reduction Type) 6G-5
Starting motor run-
ning but too slow
(small torque) If battery and wiring are satisfactory, inspect
starting motor
• Insufficient contact of magnetic switch main
contacts
Replace magnetic switch.
• Layer short-circuit of armature Replace.
• Disconnected, burnt or worn commutator Repair commutator or replace
armature.
• Worn brushes Replace brush.
• Weakened brush springs Replace spring.
• Burnt or abnormally worn end bush Replace bush.
Starting motor run-
ning, but not cranking
engine Worn pinion tip Replace over-running clutch.
Poor sliding of over-running clutch Repair.
Over-running clutch slipping Replace over-running clutch.
Worn teeth of ring gear Replace flywheel (M/T) or drive
plate (A/T).
Noise Abnormally worn bush Replace bush.
Worn pinion or worn teeth of ring gear Replace over-running clutch, fly-
wheel (M/T) or drive plate (A/T).
Poor sliding of pinion (failure in return move-
ment) Repair or replace.
Worn internal or planetary gear teeth Replace.
Lack of oil in each part Lubricate.
Starting motor does
not stop running Fused contact points of magnetic switch Replace magnetic switch.
Short-circuit between turns of magnetic switch
coil (layer short-circuit) Replace magnetic switch.
Failure of returning action in ignition switch Replace.
Condition Possible Cause Correction