Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 816 / 834

CHARGING SYSTEM 6H-23
8) Hold shaft by using hexagonal box wrench and remove pul-
ley nut, and then pull out pulley.
9) Remove 4 rear end frame nuts.
10) Drive out rear end frame with rotor tapping shaft lightly by
using plastic hammer.
11) Separate rear end frame from rotor evenly by using plastic
hammer.
12) If required, use bearing puller to remove end housing bear-
ing and bearing cover.
13) If required, remove 4 screws, retainer plate and then drive
out drive end bearing.
14) If required, remove stud bolts and then pull out stator.
CAUTION:
• To hold shaft, use hexagonal box. Duodecimal box may
cause slipping and consequential shaft or tool dam-
age.
• Do not attempt to hold pulley by using vise or pipe
wrench so as not to distort it.
1. Pulley 3. Offset wrench
2. Hexagonal box wrench
CAUTION:
Do not hit shaft at slip ring side, when separating rotor
and rear end frame.
1. Rear end frame 3. Rear end frame nut
2. Rotor shaft
CAUTION:
Care must be exercised so as not to distort cooling fan
blade while applying puller.
1. End housing bearing 3. Bearing cover
2. Bearing puller
1. Stud bolt
2. Retaining plate
3. Drive end bearing
4. Stator
NOTE:
Heating drive end frame may facilitate removal of stator.