Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 550 / 834

ENGINE MECHANICAL (J20 ENGINE) 6A4-61
9) Install intake manifold, injectors, exhaust manifold, water out-
let pipe (2) and water outlet cap to cylinder head (1).
“A” : Sealant 99000-31110
INSTALLATION
1) Clean mating surface of cylinder head and cylinder block.
Remove oil, old gasket and dust from mating surface.
2) Install knock pins (3) to cylinder block (2).
3) Install new cylinder head gasket (1) to cylinder block.
“TOP” mark provided on gasket comes to crankshaft pulley
side (4), facing up (toward cylinder head side).
4) Install cylinder head to cylinder block.
Apply engine oil to cylinder head bolts and tighten them
gradually as follows.
a) Tighten all bolts to 53 N·m (5.3 kg-m, 38.5 lb-ft) according
to numerical order in figure.
b) In the same manner as in (1), tighten them to 84 N·m (8.4
kg-m, 61.0 lb-ft).
c) Loosen all bolts until tightening torque is reduced to 0 in the
illustrated order.
NOTE:
When installing water outlet pipe, apply sealant to the
thread of the bolt shown in figure.
5. Flywheel side
1. Crankshaft pulley side
2. Flywheel side
1. Crankshaft pulley side
2. Flywheel side