Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 651 / 834

6E1-20 ENGINE AND EMISSION CONTROL SYSTEM (G16/J20 ENGINES)
TERMINAL ARRANGEMENT OF ECM (PCM) CONNECTOR (VIEWED FROM HARNESS SIDE)
TERMINAL WIRE COLOR CIRCUIT TERMINAL WIRE COLOR CIRCUIT
E61
1 GRY/RED
Output of 5 V power source for CO adjusting resistor
(if equipped)
E61
31 ORN/BLU
Selector switch signal of Power mode/Normal mode
for A/T
2 WHT Power source of ECM internal memory 32 RED/YEL Electric load signal for clearance lamp
3 PNK/GRN Heater output of heated oxygen sensor-2 (if equipped) 33 YEL/RED Selector switch signal of OD On/Off for A/T
4 – – 34 GRN/WHT Electric load signal for stop lamp
5 PPL
Duty output terminal (if equipped) 35 – –
Immobilizer indicator lamp output (if equipped)
C51-3
1 LT BLU Intake air temp. (IAT) sensor signal
6 BRN Engine revolution signal output for tachometer 2 ORN/BLK Engine coolant temp. (ECT) signal
7 PPL/YEL MIL (Malfunction indicator lamp) output
3
RED/BLU Knock sensor signal (J20 engine)
8
GRN/WHT A/C cut signal (canvas top model, if equipped)
GRY/BLK
Ignition timing adjusting resistor (G16 engine, if
equipped)
PNK
A/C compressor relay output (other than canvas top
model, if equipped)
4 BLU/BLK Main power supply
9 BLU Main power supply relay output 5 PPL/GRN Ground for Mass air flow (MAF) sensor
10 GRY/BLK CO adjusting resistor signal (if equipped) 6 BLK/GRN Ground for ECM
11 – – 7 BLU/ORN Power steering pressure switch signal
12 PPL/WHT
Serial communication line of data link connector 5 V (if
equipped)
8 RED/WHT
Manifold absolute pressure (MAP) sensor signal (if
equipped)
13
PPL/GRN (can-
vas top model)
Serial communication line of data link connector 12 V
(if equipped)
9 RED/GRN Throttle position (TP) sensor signal
10 PPL/WHT Mass air flow (MAF) sensor signal
11 RED
Oxygen signal of heated oxygen sensor-1 (if
equipped)
PPL/RED (other
than canvas top
model)
12 – (shield ground)
Ground of shield wire for heated oxygen sensor-1 (if
equipped)
14 WHT/RED Test switch terminal (if equipped)
13 GRY/RED
Output of 5 V power source for throttle position (TP)
sensor
15 BLK/RED
Electric load signal for rear defogger switch (if
equipped)
14
WHT/RED (can-
vas top model)
Output of 5 V power source for Manifold absolute pres-
sure (MAP) sensor (if equipped)
16 PNK/WHT Electric load signal for heater blower motor
17 YEL/BLK A/C request signal (if equipped)
18 – –
GRY/RED (other
than canvas top
model)
19 ORN/BLK “4WD” lamp output (if equipped)
20 WHT/BLK “OD OFF” lamp output (A/T vehicle)
21 GRY/BLU “POWER” lamp output (A/T vehicle) 15 BLU/BLK Main power supply
22
YEL/BLU
A/C condenser fan motor relay output (canvas top
model, if equipped)
16 – –
17 BLK/BLU Ground for ECM
YEL/WHT
ECT sensor signal for combination meter (other than
canvas top model)
18 BLK/YEL Starting motor signal
19 YEL/BLU Meter select signal (canvas top model, if equipped)
23 WHT/GRN
Fuel pump relay output (without immobilizer control
system)
20 BLK/WHT Ignition switch signal
21 GRY/YEL Ground for throttle position (TP) sensor
24 GRY/YEL
Ground for CO adjusting resistor (canvas top model, if
equipped)
22 GRY/YEL Ground for heated oxygen sensor-1 (if equipped)
23 – –
Ground for heated oxygen sensor-2 (other than can-
vas top model, if equipped)
24 YEL/BLU
A/C condenser fan motor relay output (other than can-
vas top model, if equipped)
25 – – 25 BLU/WHT Ground for sensors
26
RED/GRN (can-
vas top model)
Oxygen signal of heated oxygen sensor-2 (if
equipped)
26 PPL/RED Ground for CMP sensor
C51-1
1 GRN/RED Shift solenoid-B output for A/T
2 GRN Shift solenoid-A output for A/T
RED/BLU (other
than canvas top
model)
3 – –
4 – –
5 – –
27 – – 6 – –
28 BLU/WHT Fuel level sensor signal (if equipped) 7 – –
29 YEL Diagnosis switch terminal (if equipped) 8 GRN/YEL Torque converter clutch (TCC) solenoid output for A/T
30 PNK/BLK Idle up signal from ABS control module (if equipped) 9 – –