Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 483 / 834

6A2-108 ENGINE MECHANICAL (H25 ENGINE)
6) Install crankcase (1) to cylinder block. Apply oil to crankcase
bolts before installing them. Tighten crankcase bolts gradu-
ally as follows.
a) Tighten all bolts to 42 N·m (4.2 kg-m, 30.5 lb-ft) according
to numerical order in figure.
b) Loosen all bolts until tightening torque is reduced to 0 in
reverse order of tightening.
c) In the same manner as in Step a), tighten them to 42 N·m
(4.2 kg-m, 30.5 lb-ft).
d) In the same manner as in Step a) again, tighten them to
specified torque.
Tightening torque
Lower crankcase bolt (10 mm (0.394 in.) thread diameter)
(a) : 60 N·m (6.0 kg-m, 43.5 lb-ft)
Lower crankcase bolt (8 mm (0.315 in.) thread diameter)
(b) : 27 N·m (2.7 kg-m, 19.5 lb-ft)
7) Using special tools (Oil seal installer and oil seal guide),
install rear oil seal (1).
Special tool
(B) : 09911-97811
(C) : 09911-97710
NOTE:
Tighten 10 mm (0.394 in.) thread diameter bolts first (fol-
lowing the order shown in figure), then tighten 8 mm
(0.315 in.) thread diameter bolts.
NOTE:
After tightening crankcase bolts, check to be sure that
crankshaft rotates smoothly when turned by hand.
2. Bolt (10 mm (0.394 in.) thread diame-
ter)
4. Long bolt (8 mm (0.315 in.) thread
diameter)
3. Bolt (8 mm (0.315 in.) thread diameter)