Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 471 / 834

6A2-96 ENGINE MECHANICAL (H25 ENGINE)
6) Tighten bolts and nuts of exhaust No.1 pipe (1) to specified
torque.
Tightening torque
Exhaust No.1 pipe bolt and nut
(d) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
7) Install front differential housing with differential to chassis if
removed.
Refer to “Remounting” in Section 7E for installation.
8) Install steering shaft lower assembly. Refer to “Steering
Lower Shaft Assembly” in Section 3C/3C1 for details.
9) Install A/C compressor assembly. Refer to “Compressor
assembly” in Section 1B for details.
10) Install P/S pump assembly. Refer to “P/S Pump” in Section
3B1 for details.
11) Connect hoses, cables and electric wires.
12) Adjust accelerator cable and A/T throttle cable (for A/T vehi-
cle) according to procedure described in “Accelerator Cable
Adjustment” and “A/T Throttle Cable Adjustment” of Section
6E2.
13) Refill engine with engine oil referring to item “Engine Oil and
Filter Change” in Section 0B.
14) Refill cooling system, referring to “Cooling System Flush and
Refill” in Section 6B.
15) Check to ensure that all fasteners and clamps are tightened.
16) Upon completion of installation, verify that there is no fuel
leakage, coolant leakage, P/S fluid leakage or exhaust gas
leakage at each connection.
[A] : Vehicle not equipped with warm up three way catalytic converter
[B] : Vehicle equipped with warm up catalytic converter