Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 343 / 834

6A1-52 ENGINE MECHANICAL (G16 ENGINE)
9) Install rocker arms, springs and rocker arm shaft referring to
“Rocker Arms, Rocker Arm Shaft and Camshaft” in this sec-
tion.
10) Install intake manifold and exhaust manifold.
INSTALLATION
1) Remove old gasket and oil on mating surfaces and install
knock pins (4) and new head gasket (1) as shown in figure,
that is, “TOP” mark provided on gasket comes to crankshaft
pulley side (2), facing up (toward cylinder head side).
2) Check to make sure that oil jet (venturi plug) (1) is installed
and if it is, that it is not clogged.
3) Apply engine oil to cylinder head bolts and tighten them
gradually as follows.
a) Tighten all bolts to 35 N·m (3.5 kg-m, 25.0 lb-ft) according
to numerical order in figure.
b) In the same manner as in (1), tighten them to 55 N·m (5.5
kg-m, 40.0 lb-ft).
c) Loosen all bolts until tightening torque is reduced to 0 in
reverse order of tightening.
d) In the same manner as in (1), tighten them to 35 N·m (3.5
kg-m, 25.0 lb-ft).
e) In the same manner as in (1) again, tighten them to speci-
fied torque.
Tightening torque
Cylinder head bolt
(a) : 68 N·m (6.8 kg-m, 49.5 lb-ft)
4) Reverse removal procedure for installation.
5) Adjust water pump drive belt tension referring to “Cooling
Fan Belt Tension Check and Adjustment” in Section 6B.
6) Adjust power steering pump belt tension or A/C compressor
belt tension, if equipped. Refer to “Engine” in Section 0B.
3 : Flywheel side
“1” : Camshaft pulley side