Suzuki Engine 2002 GRAND VITARA SQ625, Руководство по обслуживанию

Страница: 507 / 834

6A4-18 ENGINE MECHANICAL (J20 ENGINE)
INSTALLATION
1) To facilitate and ensure installation of oil pan, increase clear-
ance between engine and vehicle body according to follow-
ing procedure.
a) Remove strut tower bar.
b) Disconnect exhaust pipe from exhaust manifold.
c) Remove engine mounting nuts (Right & Left).
d) Using engine support jack, hoist engine 2 – 3 cm (about 1
in.).
2) Apply sealant continuously to oil pan (1) mating surface as
shown in figure.
“A” : Sealant 99000-31250
3) Install O-rings (2) in the position as shown in figure and
install oil pump strainer (3) to oil pump (1).
Tighten strainer bolts first and then bracket bolt to specified
torque.
Tightening torque
Oil pump strainer bolt (a) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
Oil pump strainer bracket bolt
(b) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
4) After fitting oil pan (4) to lower crankcase, run in securing
bolts and start tightening at the center : move wrench out-
ward, tightening one bolt at a time.
Tighten bolts and nuts to specified torque.
Tightening torque
Oil pan bolt and nut (c) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
5) Lower engine and tighten engine mounting nuts to specified
torque referring to “Engine Assembly” in this section.
CAUTION:
Do not hoist engine more than instructed above. That
may cause trouble to engine or transmission.
“a” : 2 mm (0.08 in.)
“b” : 3 mm (0.12 in.)
“A”
“A”
“A”
“b”
“a”
“a”
“b”
1