Sun Microsystems Sun Fire X4140, Руководство по обслуживанию

Страница: 72 / 168

4-18 Sun Fire X4140 Server Service Manual • September 2010
4.4.3 Installing PCIe Cards
1. Unpackage the replacement PCIe card and place it on an antistatic mat.
2. Locate the proper PCIe slot for the card you are replacing.
3. If necessary, review the PCIe Card Guidelines to plan your installation.
See Section 4.4.1, “Sun Fire X4140 Server PCIe Card Guidelines” on page 4-16 for
additional information.
4. Remove the PCIe riser board.
See Section 4.3, “Servicing PCIe Risers” on page 4-13 .
5. If the server has been continuously used for an extended time, inspect the slot
for particles.
Clean the slot with filtered, compressed air, as required.
6. Remove the PCI filler panel.
PCIe filler panels are located in the motherboard rear panel.
7. Insert the PCIe card into the correct slot on the riser board (
FIGURE 4-10
).
8. Replace the riser board.
a. Slide the riser back until it seats in its slot in the rear panel.
b. Tighten the captive No. 2 Phillips screw securing the riser to the
motherboard.
9. Return the server to operation.
a. Install the top cover.
See Section 6.1, “Installing the Top Cover” on page 6-2 .
b. Slide the server into the rack.
See Section 6.3, “Returning the Server to the Normal Rack Position” on
page 6-4 .
c. Connect any data cables required to the PCIe card.
Route data cables through the cable management arm.
d. Reconnect the power cord (or cords) to the power supply (or supplies).
Verify that the AC Present LED is lit.
See Section 6.4, “Powering On the Server” on page 6-5 .
e. Power on the server.
See Section 6.4, “Powering On the Server” on page 6-5 .