StorageWorks EK-SMRAB-IG, Руководство по установке

Страница: 29 / 84

Chapter 2. Creating an Initial Controller Configuration
EK–SMRAB–IG. B01 2–3
The controller responds with a display similar to that shown below:
CONTROLLER:
HSZ20 CX44332211 FIRMWARE V27Z-0, HARDWARE A02
SCSI ADDRESS 7
TIME: NOT SET
HOST PORT:
SCSI TARGET(S) (0, 1, 2) NO PREFERRED TARGETS
CACHE:
16 MEGABYTE WRITE CACHE, VERSION 2
CACHE IS GOOD
BATTERY IS GOOD
NO UNFLUSHED DATA IN CACHE
CACHE_FLUSH_TIMER = DEFAULT (10 SECONDS)
CACHE_POLICY=A
HOST FUNCTIONALITY MODE=A
LICENSING INFORMATION:
RAID (RAID OPTION) IS ENABLED, LICENSE KEY IS VALID
WBCA (WRITEBACK CACHE OPTION) IS ENABLED, LICENSE KEY IS
VALID
MIRR (DISK MIRRORING OPTION) IS ENABLED, LICENSE KEY IS
VALID
EXTENDED INFORMATION:
TERMINAL SPEED 9600 BAUD,EIGHT BIT,NO PARITY,1 STOP BIT
OPERATION CONTROL:0000004 SECURITY STATE CODE:85780
CONFIGURATION BACKUP DISABLED
Examine the display to verify the following information:
Controller SCSI target number is recommended to be set to 0.
If the target number is not 0, use the following commands to set the SCSI target ID
for the controller (ensure that there are no other SCSI devices using the same IDs as
configured for the RAID Array 310 controller):
HSZ20> SET THIS_CONTROLLER ID=0
or
HSZ20> SET THIS_CONTROLLER ID=(0, 1, 2)
If you want to use multiple SCSI Ids (as is done in the following examples).
Cache condition should be GOOD
If the Cache condition is BAD then call your sales person for unit service.
Battery condition should be GOOD
If the battery condition is LOW, allow the battery to charge with the subsystem
power on for up to 6 hours. The battery must be fully charged to protect the data in
the Write Back Cache. If the battery condition is still LOW after 6 hours of charging,
then call your sales person for unit service.