Siemens ADVIA 2400, Руководство оператора, Страница: 90 / 200

90 ADVIA 2400 Operator’s Guide
Performing a system-assisted shutdown (Shutdown set)
1. Verify that sufficient system reagents and wash solutions are available for the startup
you want to run.
2. At the Menu Panel, select
Maint.
, then select
System Startup/Shutdown Settings
.
3. In the Mode set list, select
Shutdown set
.
4. Verify the selections for the shutdown you want to run.
If no shutdown is defined or you want to change an existing one, proceed as follows:
a. For each of the Proc. set, Set1, Set2, or Set3, you can select one of the following:
(1) In the System p.s. area, if you want the system to turn off analyzer power
after the shutdown is completed, check the box next to Power OFF.
(2) In the System end area, select the software shutdown mode you want.
(3) In the PRIME area, select the prime you want to run or select
NONE
.
A Prime is required only if a system reagent is replenished or a related
component is replaced.
(4) Select the check box next to each wash you want to perform.
Select
WASH2
for the shutdown wash.
b. Select
Save
.
c. To confirm, select
Yes
.
5. In the Select wash routine area, select
Shutdown
.
6. In the Proc.set list, select the shutdown setting (Set1, Set2, or Set3) you want to run.
7. Verify that the system is in Ready mode.
8. In the Start selected routine area, select
Yes
.
The current operating mode displays in the System mode box, and the time remaining
to complete the shutdown displays in the Time until end box.
9. To halt the shutdown, do the following:
a.
At the System Startup/Shutdown Settings window, select
Stop
.
b. In the Start instructions area, select
Cancel
.
c. At the Operation Panel, select
Stop
.
NOTE:
To avoid entering the Wait state and not shutting down properly, do not use the
Exit command from the System(S) menu on the Menu Panel.