78
2. TROUBLESHOOTING FOR FAULTS IN GENERAL
Alarm
Check points
Treatment
Motor doesn’t
run
Check connection of power supply to
terminals L1/R, L2/S, L3/T?
Input power supply
Supply power again after power firstly interrupted.
Verify voltage class of power supply
Tighten screws for terminals
Check voltage output from output
terminals U, V, W.
Supply power again after power firstly interrupted.
Check motor is not blocked due to load
over-large
Decrease load to make motor running available
Check fault of inverters
Check wiring and correct it if necessary in
accordance with reference for alarm.
Check fwd/rev run reference achieved
Check input of Analog frequency setting
Verify wiring for analog frequency input signal
Verify frequency input set voltage
Verify operation mode setting
Controlled by digital operator.
Contrary rotation
direction of motor
Check wiring for output terminals U, V, W
Match correctly with terminals U, V, W of motor
Check wiring for FWD/REV run
Verify wiring and correct if necessary
Velocity variation
unavailable for
motor running
Check wiring for analog frequency input
Verify wiring and correct if necessary
Check operation mode setting
Check and verify operation mode setting
Check motor is free from overload.
Decrease load
Motor running
speed over high
or over low
Check specification(number of poles and
voltage)of motor
Confirm specification of motor
Check gear proportion
Confirm gear proportion
Check Max output frequency setting
Confirm Max output frequency setting
Check voltage is not dropping at motor
side
Verify V/f curve setting
Speed variation
fault during
motor running
Check motor overload
Decrease load
Check load is not in sharp variation
Decrease load variation
Increase capacity of inverter and motor.
Check no phase failure occur to power
supply
For single phase mode, fix AC reactor to power
supply side
Verify wiring for Three phase mode.
