34
0-06
Software Version
Factory setting
d #.##
Setting range
Non
Software version is only for reading.
0-07
Input parameters password protection
Factory setting
d 0
Setting range
d 0<->d 999
d0
No code locking or correct code has been input
d1
Parameters have been locked
When this parameter indicates as d1, all parameters have been locked. Correct password must be entered to make
this parameter able to write. This parameter will display d0 after entering the correct password. It will be locked again
if incorrect password is entered.
After having entered the correct password, all parameters can be set before this interruption of power supply.
However, if the value of 0-
08 isn’t cleared, which means the password protection function hasn’t been cancelled, the
correct password must be e
ntered again to modify parameters when power on next time. “End” will be displayed
whether the parameter password is entered correctly or not, otherwise “Err” will be displayed.
This password has three times of entering limit to prevent from entering password arbitrarily. If enter wrong password
three times continuously, “Err” will be displayed. It is necessary to reboot the power supply to enter password again.
0-08
Set parameter password protection
Factory setting
d 0
Setting range
d 0<->d 999
d0
Code not set
d1
Code set
This parameter is set to 0 when no code was set. All parameters shall be locked so that they can only be read, but
not modified, if it is set to numbers other than 0. When this parameter is d1, modification of parameter will be
displayed “Err”. Decode the parameter through 0-07 to reset the new password.
0-09
Reserved
